grain slag cement

  • Engineering Seminars: SLAG CEMENT - Blogger

    Slag cement should be substituted for Portland cement on a one-to-one basis by mass. Specific gravity of slag cement ranges from 2.85 to2.94, depending upon the slag cement source-as compared to 3.15for Portland cement. The difference in specific gravity means a greater volume of slag cement will be used to replace the same mass of Portland cement.

  • Blast Furnace Slag Cements – Phase Analysis Using ...

    Jun 21, 2011 · Blast furnace slag is mostly an amorphous product, comprising little amounts of crystalline phases such as Akermanite (Ca 2 MgSi 2 O 7), Merwinite (Ca 3 MgSi 2 O 8), or Quartz (SiO 2). It offers hydraulic properties same as those of Portland Cement and thus may partly substitute the clinker component in cement blends.

  • Technical Report UDC 669 . 162 . 275 . 2 : 666 . 943 . 2 ...

    grind blast furnace slag cement to Blaine specific surface area ex-ceeding 4 2500 cm/g and any cement of that grain size could not be injected into extremely fine cracks. In the face of such problems, efforts were made to study the mechanism of cement agglomeration during grinding and .

  • Ground granulated blast-furnace slag - Wikipedia

    GGBS cement can be added to concrete in the concrete manufacturer's batching plant, along with Portland cement, aggregates and water. The normal ratios of aggregates and water to cementitious material in the mix remain unchanged.

  • What is Slag Cement

    Slag cement is a hydraulic cement formed when granulated blast furnace slag (GGBFS) is ground to suitable fineness and is used to replace a portion of portland cement. It is a recovered industrial by-product of an iron blast furnace.

  • Portland Slag Cement (PSC)

    Portland Slag Cement, commonly known as PSC, is blended cement. Slag is, essentially, a non-metallic product comprising of more than 90% glass with silicates and alumino-silicates of lime. At JSW Cement, we use superior quality slag produced at our steel manufacturing plant, conforming to IS: 12089 standards for producing PSC.

    [PDF]
  • XRD | Cement Science

    The main hydration products of the slag-cement are C-S-H gel, Ca(OH) 2, the sulpho-aluminate hydrate phases AFt and AFm and a Mg, Al-rich hydroxide phase. Fig. 1. Transmission electron micrograph showing foil-like Op C-S-H in a water-activated slag paste hydrated for 3 1/2 years at 40°C (W/S = 0.4) (by I.G Richardson: The nature of C-S-H in hardened cements).

  • What is slag cement.any advantages or disadvantages over ...

    I had practically used PPC cement in almost all projects. I didn't find any problem. Portland Slag Cement (PSC) Portland Slag Cement (PSC) is manufactured by either inter-grinding in the Portland cement clinker, Gypsum & Granulated Slag or blendin...

    [PDF]
  • Specific Gravity Of General Materials Table - CSGNetwork

    The specific gravity of all other materials are compared to water as a fraction heavier or fraction lighter density, no matter how small or large the fraction is. For example, ammonium nitrate has a specific gravity (sg) of 0.73 while dry ammonium sulphate has a sg of 1.13 (1130 kilograms/cubic meter).

    [PDF]
  • Standard Specification for Slag Cement for Use in .

    Standard Specification for Slag Cement for Use in Concrete and Mortars1 This standard is issued under the fixed designation C989/C989M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval.

  • Effect of Red Mud Content on Strength and Efflorescence in ...

    of the dried red mud is 23.53 m2/g and the average grain diameter is 2.75 lm. The average grain diameter of red mud is even smaller than that of micro-cement (4–6 lm). The small particles can provide a packing effect on binder matrix and strength development so that strength reduction due to efflorescence can be compensated (Al-Akhras and Smadi 2004).

    [PDF]
  • Features of Slag Storage Silo and How to Build a Slag ...

    Install slag storage silo's roof: using cutting machine to make the silo roof horizontal and then install the silo roof; Build the slag storage silo up to the designed height, and then pull out the machine, drop the slag silo on the ground, make the silo body connects with pre-embedded parts in the ground.

  • Hydration of slag-blended cements - ScienceDirect

    The water to binder ratio of the slag-blended cement paste was 0.4 and the paste was cured at 20 °C until the time of the test. The pastes contained 60% of each of the slags shown in Table 9 and 40% of the same clinker. The degree of reaction of slag in the blended cement paste was .

  • (PDF) The use of steel slag in concrete

    steel slag as a substitute for nat ural aggregate with the maximum grain size of 12.5 mm and concrete based on natural filler – l imestone are presented in [2]. The results of a research, where ...

  • Slag Cement Suppliers & Manufacturers - CEMEX USA

    Slag cement lowers the heat of hydration of a concrete mixture, which reduces the risk of early age thermal cracking, a major benefit for large or mass concrete placements. It lowers the total alkalis of a concrete mixture thus reducing the risk of alkali-silica reactions. Equally important, slag cement delivers improved workability.

  • Steel Silos | Cement Silo | Grain Storage Silo - Flyer

    Our steel silo adopts double-sided galvanized steel coil and the most advanced spiral bending technology, has stable structure, corrosion resistance and good air tightness. We provide flexible choices on dimensions in a fairly large range to meet various demands, and a comparably small coverage that could narrow the separation distance down...

  • Fly Ash, Slag, Silica Fume, and Natural Pozzolans, Chapter 3

    Fly Ash, Slag, Silica Fume, and Natural Pozzolans Fly ash, ground granulated blast-furnace slag, silica fume, and natural pozzolans, such as calcined shale, calcined clay or metakaolin, are materials that, when used in conjunc-tion with portland or blended cement, contribute to the properties of the hardened concrete through hydraulic or

  • Bulk Density Table - Sawyer/Hanson Innovations

    Brewer's grain, spend, dry 14 30 Brewer's grain, spent, wet 55 60 Brick, ground, 1/8" 100 120 Bronze chips 30 50 Buckwheat 42 47 Calcine, flour 75 85 Calcium carbide 70 90 Calcium carbonate (see limestone) Reference Information Ingredient Bulk Density Table

  • Blast Furnace Slag - Material Description - User ...

    GGBFS is used as a mineral admixture for Portland cement concrete. Granulated blast furnace slag and vitrified pelletized blast furnace slag are also used in the manufacture of blended hydraulic cements (AASHTO M240).

  • How to Stain Concrete: Adding Color to Cement Surfaces | HGTV

    When adding any translucent color to anything, the pattern and colors of the substrate will show through. It's similar to applying a wood stain to a piece of wood with knots and wood grain. Concrete stain can actually highlight and intensify the variations found in the concrete — natural as well as man-made blemishes and markings.